MOTOR PROGRAMMING 

 PW ROLLER SHADE MOTORS 

 

4 – Wires from motor side

4. Red = Direction 1
   
5. Black = Direction 2
   
6. White = Neutral
   
7. Green = Ground
   

 3 – Wires from house side [Wire color may differ]

3. Green = Ground
   
4. White = Neutral
   
5. Black = 120VAC
   

SPDT center neutral [Leviton 5657-2W]– rocker switch [A licensed electrician required to complete wiring connections]

4. Red (Direction 1) motor wire to “UP” activated position on control switch
   
5. Black (Direction 2) motor wire to “Down” activated position on control switch
   
6. White (Neutral) motor wire combined with neutral house wire
   
7. Green (Ground) Motor wire combined with house ground wire
   

 Motor rotation direction

1. Confirm travel direction of shade: Press “Down” on switch and confirm direction of shade moves down
   

1. Motor on right side of window: Red (Direction 1) is “Up” & Black (Direction 2) is “Down”
   
2. Motor on left side of window: Red (Direction 1) is “Down” & Black (Direction 2) is “Up”

2. If travel direction is reversed swap Direction 1 & 2 wires on rocker switch
3. Confirm travel direction of shade matches switch
   

Setting motor limits [Motor wired to switch required]

2. Identify the “Orange” program button on the head of the motor at end of shade
   
3. Set bottom limit: Press “Down” on switch, once shade reaches desired bottom limit; simultaneously press the “Orange” program button on motor
   

2. If shade stops prior to desired bottom limit: simultaneously press “Down” on switch and tap or hold “Orange” program button on motor until desired bottom limit is met
   
3. If shade exceeds bottom limit: Press “Up” on switch passing desired bottom limit and repeat instructions 2 – a.
   

3. Set upper limit: Press “Up” on switch, once shade reaches desired upper limit; simultaneously press the “Orange” program button on motor
   

2. If shade stops prior to desired upper limit: simultaneously press “Up” on switch and tap or hold “Orange” program button on motor until desired upper limit is met
   
3. If shade exceeds upper limit: Press “Down” on switch passing desired upper limit and repeat instructions 3 – a.
   

4. Test top and bottom limits are set

REV1-10.18